|
|
LinkBack | Thread Tools | Display Modes |
#11
|
||||
|
||||
Bunnings.
And that's not me being silly. Takes a few minutes to do the mod.
__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR] |
#12
|
||||
|
||||
you may also need a long weight
|
#13
|
||||
|
||||
And remember loctite.
|
#14
|
||||
|
||||
Quote:
thanks all i think this may call for a DIY walkthrough with pics So i gather this hole is on the back of the BOV.. Go to bunnings, get a Grub Screw and loctight - licktight the grub screw and screw it in the hole!! sound about right were does the long weight come in to place Cheeers |
#15
|
||||
|
||||
Quote:
__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR] |
#16
|
||||
|
||||
its also often useful to use a left-handed screwdriver
|
#17
|
|||
|
|||
4500 rpm? Christ, id be suprised if a half cut truck turbo on a 2ltr would spool later then 4500 :/
__________________
Honda Hannspree Edition CBR 600 RR - SOLD Yamaha FZ1N - Purchased |
Tags |
aftermarket, bov, fmi, processwest |
|
|