does anyone know where i can buy a silicone inlet hose for my my99. My supplier of Autotecnica ones has run out. I can find them all over Ebay, but i hate Ebay.

__________________
[SIGPIC][/SIGPIC]
Yes baby, I could be in the shed for a while!

Pointless to upgrade unless you are chasing more than 200kwatw. As told to me by Sean at ASG after i installed one and got a retune. Did nothing.

http://www.tuspeed.com/product_info....products_id=61

http://www.prospeedracing.com.au/pro...B47%7DSTi.html

and even Vision r in o'conner have em

__________________
race tape y pipe running .05 bar till spares turn up.

+ 1 for PSR.

And contrary to popular belief... theyre an easy change out...

(Arent they Mark...? )

Brent.

__________________
* [REXPLOIT] - EJ207 2.2L build. Under assembly:
* All Sling - No Bling: Member 002:
* WRX Club of WA member / CAMS member / CAMS registered volunteer:

[SIGPIC][/SIGPIC]

do they come off easier on the my99's compared to the my04/05? My stock one broke when it was taken off.

That question is easily answered... once u decide "do i want to keep the standard part intact, to store it, sell it, etc"



Marks patience was ahhhh... 'wearing thin'.... after trying to do this. (although succeeding). Personally, I find it very simple. And about 5 mins to fit...



ok yes, I had half my engine bay out, and the intake manifold off....

Brent.

__________________
* [REXPLOIT] - EJ207 2.2L build. Under assembly:
* All Sling - No Bling: Member 002:
* WRX Club of WA member / CAMS member / CAMS registered volunteer:

[SIGPIC][/SIGPIC]

I found it a damn horrible job!

i found a bit of dremel love did the trick and yes much easier withe half the engine missing

__________________
race tape y pipe running .05 bar till spares turn up.

cheers guys, found one at vision R. I am not looking for performance, just want this piece of shit to idle right for the first time in 2 years. 280Km to a tank also sucks!

__________________
[SIGPIC][/SIGPIC]
Yes baby, I could be in the shed for a while!