hey guys bought a pro speed intake and the short fat bit, wondering how you join the 2 together? turbo -> long L shaped peice -> short fat peice (dow do you join them toghter? they seem to be the same diamiter, was thinking a peice of pipe to slide into both of them them clamping them?)
cheers for the help
matt

^^ Yep, i did the same. Only a small ~50mm bit of pipe inside to get 2 ring clamps on.

__________________
[SIGPIC][/SIGPIC]
Should have bought an STI

Can you take pics for future reference?
I was looking at getting one last night actually lol

So you have one of these two? You see the silver bit, on the end of the L one, that should be on / in there to clamp the fat piece too. The silver piece on my Perrin intake moved and needed two clamps, but depending on the build you should / may get away with one.

As for the turbo to L piece, should slip over and use one clamp, as per old plastic piece.

Hope this helps.

Attached Thumbnails

   

__________________
Cheers,

Simon.

yeh i got the pro speed racing one, didnt have the metal ring on the end of the l peice.
and yes i will take pics of the install any tips ( i know theres posts about this) but was hoping for any thing that could be helpful for me
cheers

what sort of pipe? pvc? or s/steel?

Thanks, will keep an eye for update, what did it set you back out of curiousity?

About 300, 350 something around that, just the prices on the site man

Just so you know, some of these intakes may require you to lift / remove the intake manifold to get it in / old piece out. Did it come with any instructions? Also, contact pro speed and ask them how are you supposed to join them together. I would think they should supply the part you require to join the L and the fat piece. I may be wrong though.

__________________
Cheers,

Simon.

Get some 3 inch intercooler tubing, cut and add weld to create lip and done.

I have a PSR intake, best method to get it in is lube it up, then use cable ties to make the diameter smaller and elbow grease it in.