|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
Turbo seals or tired motor
Hey guys my rs lib with a sti spec (rs closed deck block,forged Pistons running vos chip) is chewing lots of oil ie if reg using boost a whole dipstick a week. Now it runs fine but when I start her up she lets heaps of white smoke out then stops. It's not steam but oily fuel smell she does not lose any coolant or get hot.
Now she does have a slight miss even with new gapped down plugs through s tecnik in maddington but no missing at all through the rev range. She is booked in with them on 14 October for a compression test any thoughts. The miss at idle is not constant a couple of times every minute. Thanks mark |
#2
|
||||
|
||||
Its probably due to it being installed up-side-down
|
#3
|
|||
|
|||
sounds like rings . Id be doing a compression test at the least.
|
#4
|
||||
|
||||
Quote:
On the bright side I'm quite impressed how it goes for a tired motor. Last edited by Rslib72; 02-10-2014 at 05:14 PM. |
#5
|
||||
|
||||
Ha ha just noticed the pic I better go out and flip it over....
|
#6
|
||||
|
||||
Rather than book it in for just a compression test, how about just simply booking it in to diagnose the problem? A compression test may be a part of the workshops diagnosis, but they might find the problem with their experience of just hearing the engine idle, or drive, or....
What Im getting at is: just ask them to diagnose and let them determine what needs to be done to find the problem? Does that make sence? I hope so? |
#7
|
||||
|
||||
Yeh cheers mate that's what's going to happen went in explained the prob compression test is just one of the things they are going to do. The guys at s tecnik know there stuff just the slight miss at idle drew there attention to a cylinder dropping. They are flat out till the 14 October so I i'll report on the diagnosis.
Mark |
#8
|
||||
|
||||
Well bugger me silly all my probs with the car at this stage have been due to a blocked pcv valve and all the breather hoses to old and collapsed so deleted the pcv and set up a catch can.Did this yesterday has stopped going through all the oil,missing has stopped at idle along with the smoke.
So fingers crossed it's all good I only checked because a friend of mine with a 1jz chaser had similar probs and told me to check out the pcv valve. Mark |
Tags |
motor, seals, tired, turbo |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
IHI VF series turbos | cheating_gets_it_faster | Mechanicals | 2 | 21-05-2015 03:39 PM |
IHI Turbos - Specs and FAQ | pmh | Mechanicals | 308 | 15-04-2015 12:25 AM |
Twinscroll turbo setup | jEstEr? | For Sale | 5 | 12-01-2010 09:11 AM |
FS Garret GT40R turbo with blown seals | trainwrex | For Sale | 1 | 05-12-2009 09:20 AM |
New turbo | bojan07 | Mechanicals | 66 | 04-08-2008 10:05 PM |