Hi All,

This has been asks on another forum, but got no replies. Hopefully i might get a response here.....

Just having some trouble finding someone that is able to help with tuning in my kelford 272 Cams, these have been in the motor about 3 years ago then taken out for this very reason (Company couldn't tune them in - apparently). Recently I have had the car remotely tuned by someone in NZ. This tuner said that he has tuned and is willing to tune the cams in remotely. Which is fine, but would rather a dyno tune.

Just wondering if anyone has had Cams tuned on a dyno, prefer WA.

Quick run down of my car -
ADM 2008 STi- Stage 2 Closed deck bottom end (Billet rods, forged pistons, hardened race bearings, machined and balanced), Hi-Volume oil pump, Hyperflow CAI, AVO TMIC, Full 3" Greddy Exhaust, Aquamist HFS3-v2 PWM valve system with a 0.6mm jet. The fuel pump has been upgraded as well.

I recently purchased the following from -

DeatschWerks Bosch EV14 Fuel Injectors Top Feed 1000cc, Equal Length Exhaust Manifold/Headers with HEAT COATING, Blouch RBK Dominator 1.5XTR Turbo

I am going to remove the engine transport it to Perth (I live 1600kms north) and have someone install the CAMS, install the above gear myself. Then have it tuned......I have had a few responses from WA workshops, basically saying to leave the Cams out, the car has variable timing and this is enough blah blah....

If anyone can point me in the right direction to a workshop that has done Cam Shaft Tuning, it would be appreciated!

Thanks