Does anyone have a gc8 v3/4 service manual.
Need to know resistances for crank angle and cam angle sensors.

Why?

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Why not? Haha.
Trying to figure out if a sensor is buggered.
In reply to your which wires are spliced.... None, harnesses have been changed at ecu and all wires are white so have to go by pin location

Has it had another make of ecu in it apart from the powerfc and the stock one?

Re: Sensor check: Just check them for continuity.......They're a magnet and a coil of wire resistance doesn't doesn't really matter as long as the circuit isn't 'open'.

Can't figure why the harness has been modded to that extent.

Go to www.pdftown.com for the gc8 manuals
(password on the PDF's is 'pdftown')

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Had 2 powerfcs, lap timers, boost cont etc, I think it just got messy so got new harness.
Alright cheers man.
Hopefully have it all sorted soon