anyone replaced one of their factory narrowband o2 sensors with this kit and used the nbsim with the stock ECU? Would be keen to hear results and/or how hard it was to set up?

connect 1 wire to factory O2 harness and you're done!

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

I did do the cal but no luck unfortunately


Sent from my iPhone using Tapatalk

Then your sensor has expired

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Look what arrived just now!



The display is tiny! it's just 27 x 20 mm

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Thats a perfect size for what I want to do ,should be perfect size for you too hey Rossco. How long did that take 10 days?

actually it took 19 days but I chose the snail mail method

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

Hijacking like a pirate here, but I've had a narrowband gauge in my car for years, and it's as pointless as a spare cock, and I want to replace it with a wideband gauge, but in the existing 52mm pod. I know Autometer and AEM and a few others do a round dial gauge, but what's the best to go for?

__________________
Air is for pussies.

Have a look at the link Rossco put up in this thread . I got the digital one same as him but they do an option for a pod gauge as a kit in the listings think it might be 10 bucks more from memory . Still has the same Bosch wideband sensor and control box with outputs for engine management , just a different gauge.

This is the gauge kit link

APSX D1 WBO Controller and G2 Analog Gauge Full Kit | APSX Wide-Band Air/Fuel Ratio Tuning

Cheers mate, aesthetically I'd prefer a digital dial, but I'll keep it in mind.

__________________
Air is for pussies.