F...k Tode you are getting yourself some serious hardware!! can't wait to see all this stuff bolted on and tuned - on ya!

__________________
______________________

Bruce
08 STI - Ugly Betty Bites!!

Nice work mate, looks tidy.
Keep at it.

__________________
Ay Der Una Brutha Cuz! Got a Dolla Mate?

Update:

Gettin ready to install the aquamist kit. Got this bracket made up by Racelink, to fit to the spec c tank - which holds the sureflo pump and surge vessel.




Also arrived was my Autometer Dash Bezel - and a Defi Red Racer 52mm boost gauge - the other side holds the aquamist gauge/controller.

good work tode, where did you get the Autometer Dash Bezel. I have Defi Racer boost and oil pressure 52mm guages on order and still trying to figure out how and where to mount them in the Libo.

__________________
Funny looking German Subaru

dave, got it thru a nasioc vendor - around $80 delivered.

cheers tode will have to check nasioc out

__________________
Funny looking German Subaru

looks to be the goods.
have you tried the cf driveshaft yet?
if so how did it go?
how much$$?

No I havnt installed it yet, It will go on once the perrin headers and sump get installed. Do everything at once.

This weekend I installed the Aquamist kit.











Getting a unusual problem with the defi gauge -

sometimes it turns on at accessories and sometimes it doesnt turn on at all.

Going for a drive after it hasnt turned on - it sometimes comes on if I indicate etc - I'm pretty sure I have used the correct wires - I spliced into the earth that goes to the radio harness bracket/box - bad earth????

sounds like it could be a dodgy earth Tode!...

Hard wire it onto the metal plate that holds the stereo in...

__________________
www.ToonMyRide.com.au

'04 E46 S/C M3 Coupe

got a few more things pop into work today..

AVO 16psi actuator

AVO 50/50 adjustable bov
- thing is massive, steve from AVO assured me it will not leak under 2 bar - it can be made full plumb back or 50/50 taking of the little plate.