That should work well with the external gate and rotated. Fun times ahead.

Nice rotated adapter
Did you make that ?

Na nic at asg made the first one and then a jig ... he then sent them to kyle at 6boost and got a heap made up

using the Perth-WRX mobile app

few update pics heads are back from service and repair
picked up a turbo smart 40mm v band waste gate
also my je 92.5 mm pistons arrived and was able to check deck hight which is right this time
plus I'm trial fitting a few spots for my new intercooler








using the Perth-WRX mobile app

Small update
Heads repaired all valves replaced that was fingered (was cause of low comp) , replaced dammaged buckets (all of them was fingered from oil pressure loss) .. new 207 block, crank, rods and pistons all at galloways (same shop daz used) . Block is being torque plate bored and honed, crank is getting a polish and crack test as well as balance checked and journals measured, rods being weighed and bearing end getting a hone and measured for bearings. .

Once back just need head gaskets and start screwing it together


using the Perth-WRX mobile app

Few pics of the block on cnc my mate a galloways sent me .. was torque plate hones after this step


Ir should be ready to collect tomoz or early next week


using the Perth-WRX mobile app

On way to collect!!! Long weekend build i think so

using the Perth-WRX mobile app

So itl be ready for next sunday arvo session?

__________________
Doing it for all the wagons out there

Not likely need new dump, screamer and fmic pipes, twinplate clutch and tune

using the Perth-WRX mobile app

...then new tyres

__________________
MY01 JDM EVO VII - 230KW / 430NM @ 1.6BAR