|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
How to reset acceleration controller
There is a method to do this if your idle revs are playing up.. Does anyone know how to do this??
|
#2
|
||||
|
||||
airflow meter?
|
#3
|
||||
|
||||
Idle playing up?
Rpm hunting all the time? (i.e 500 rpm then over 1000 then back to 500 over and over?) Car continues to pull after lifting all the way off the accelerator pedal when in gear? Failing or FAILED Airflow meter........ Get it checked or BOOM!!!!
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#4
|
||||
|
||||
My car does somthing similar but random when im reversing and only when im reversing, the revs seem to pick up randomly... is that normal?
__________________
Aint nuthin to it but to do it! |
#5
|
||||
|
||||
Hrmm u got to rev the car at a certain revs constantly for a certain amount of time, then switch the car off for 10 seconds, then back on and rev it again.. you do that about 6 times +.. the more the better.. (I am not sure about the times and revs) Its called a Idle Reset.
|
#6
|
||||
|
||||
Quote:
How do you enter the "idle setting mode" on a GC8? How does reving it reset the IDLE speed?
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#7
|
||||
|
||||
Sure it isnt an earthing problem?
Had similar things going on with my car, put on a few extra earth leads and no more worries. |
#8
|
|||
|
|||
Does it still do it with A/C off and stereo, lights etc off?
|
#9
|
||||
|
||||
Hunting Idle & throttle off speed holding are signs of a dead MAF in a GC8
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#10
|
||||
|
||||
Quote:
I was told about this from Subaru Dealership, ring up and find out more, like i said i could only briefly remember. He did ask for the method to adjust the revs.. Last edited by tropikal; 07-05-2009 at 05:04 PM. |
Tags |
acceleration, controller, reset |
|
|