Ok, going to tackle the 08+ Brembo install.

What parts are required to complete this?

So far:
Calipers - Check
Discs - Check

But I've been told I need some bolts that have a different pitch on the brembos to the standard brakes? Can anyone tell me a part number or where to buy?

Also, are there any good one man brake bleeder kits?

Any info is much appreciated!

__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR]

The Brembo mounting bolts use a 1.5 thread pitch as opposed to the Subaru 1.25.

__________________
RS Liberty - Because WRX's are only good for parts...

One man bleeder systems are shit. Get George on the pedal John!

__________________
www.racewars.com.au

Excellent... I needed some backup on that plan

__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR]

I second that!

P.S. Sounds like I'm in a gay relationship!

__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR]

QFT

You will run into difficulties fitting the 2008 rears to a GC.
The front discs will have the wrong stud pattern unless they came from Liberty STi not a WRX STi.

Also, I know you know better but in case any noobs may read this in the future, do not buy any bolts for your car, especially caliper bolts from Bunnings!

Except for Tino, his car thrives on Bunnings bolts!

john, i reckon all you'll need will be the backing plates. then remanufacture the centre of the plate to remount up to the 4x mounting bolts on the rear hub.

__________________

Long live the WRC

Speak to Ramon, he has the 08 STi brakes on the 201.

__________________

221.7KW-ATW 498.5NM MMS ROLLER DYNO & BUILT BY STi NINJAS, BUILD #318/600

EBISU SUBARU, SHIBUYA-KU TOKYO