Hi guys, I am going to install my gauges this weekend. I was wondering if anybody knows where this goes?





Cheers

__________________
:)

You can get a oil-filter adapter plate...but i think the better way is to use the oil galley in the block:

http://legacygt.com/forums/showthrea...ey-24956.html?

not a rex...but basically the same process.

anyway see if that helps - i got the parts at Ossi Park.

Dan

__________________
My profile picture is a lie - i have no subaru

As per top thread in DIY section... Didnt even need to search...

http://www.perth-wrx.com/vb/diy-mech...-sensor-2.html

See Rossco's post

Yep...use the link OneTen provided - much better!

__________________
My profile picture is a lie - i have no subaru

I have no idea how i missed that. Cheers guys

__________________
:)

So it seems to be slightly different on my car..





Can somebody please confirm that this is the correct plug? Cheers

__________________
:)

No, it's not.

Refer to my build thread for clearer pictures of where the plug is.



In this image you can see me holding the PCV/crankcase rear breather out of the way to get a clear shot of the oil temp sender location, Usually the pcv line runs directly over the top of the sensor's location.



This ^^ shows how far towards the rear of the crankcase the sensor location is.

HTH!

Rossco

__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER]
[CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER]

http://www.perth-wrx.com/vb/mechanic...-build-19.html