03-08-2015, 07:39 AM
|
 |
Ambitious but Rubbish...
Member
|
|
Join Date: Dec 2008
Location: N52°21’48.173”, W1°40’20.283”
Posts: 2,883
Thanks: 28
Thanked 154 Times in 103 Posts
|
|
Quote:
Originally Posted by Bram
When installing a 6pt harness to a Subaru, is it acceptable to use the bolt hole for the front seat, inner rear leg to secure the lap-sash?
|
Yes. This is the usual mounting point.
Quote:
Originally Posted by Bram
The crotch straps I have put metal base plates on the underside of the car, and threaded the eyebolts into. There is a reinforcing ridge in the floor of the car directly below the seat, and I have put the crotch strap base plates on either side of the reinforcing ridge directly below the seat opening. This seams like a strong point. And lines up near perfectly with the seat position.
|
Usually you weld a bar inside the cabin under the seat which is used to mount the crotch strap to.
I have seen it done with doubler plates going through the floor, but most the only thing to note here
is that if something happens to catch the bolt head underneath the car, it may rip you nutsack off.
__________________
[COLOR=RoyalBlue][B][I]Titanium Reinforced[/I][/B]
MY00 Impreza WRX | MY11 Liberty GT Premium[/COLOR]
Last edited by Saint_23; 03-08-2015 at 07:41 AM.
|
Similar Threads
16Likes
Threaded Mode
