Like I said in my previous entry I will be getting some seat time.

Time to put all these mods to use and learn to drive better.

Going to be heading down for the November and Decemeber No Limits Nights (and many more hopefully).

Just need to arrange stickers + tagged extinguisher (I have one I bought a month ago, need to get it tagged or get a tagged one...always forget where to get them from).

Cannot wait.

-Shane :)

So I did do that independent dyno run at MMS (in regards to my "lack of torque").

Car runs 197kw (265HP)/390Nm on the MMS dyno. Same dyno as RaceTorque but MMS do dyno runs in 3rd (boost is actually not 17/18psi, more like 19/20psi already).

As I learn more about dyno readings from teh interwebs, p-wrx and workshops I am content...actually more than content with the car (i.e. Im not hooked on one dyno run or ten dyno runs for that matter).

...

After doing a lot of research and thinking not mention the enormous amount of research done by Andrew (GTB Liberty) as well (thank you so much mate) I am skipping Brembo's. Too much cash to make it all happen (that is, a brand new set from the U.S. is the better part of $5k inc shipping...meh).

Going to just go for more aggressive pads (they are consumables along with rotors so meh).

So my options for pads (front and rear):

Ferodo DS2500 (loved these...

Just like my SSR's, I have wanted these for a long time.

Jap wheels = Jap nuts (for me). Was either these or blue RAYS' nuts but I can't say no to Project Kics with a titanium coating.

[IMG]http://img854.imageshack.us/img854/1348/p1010410co.jpg[/IMG]

Thanks to Wei @ Vision R

-Shane :)

Just got an email from JDMconcept that my wheels will be arriving @ customs (over east) this week.

Meaning that my wheels aren't far off and I will not only have new SSR's + Project Kics nuts but also a freshly tuned car to play with soon.

Didn't expect to get contacted this week...will have to ring Wei @ Vision R and organising some Project Kics nuts soon.

Yay.

-Shane :)