|
|
LinkBack | Thread Tools | Display Modes |
#91
|
||||
|
||||
good stuff
u should take those headers off and port the fukers while it is stil easy im sure stacey will show u how |
#92
|
||||
|
||||
mmmm quite a bit of effort going into this-hope you get the wiring diagram sorted
__________________
05 STi Spec C Type Ra 04 LL Bean Outback |
#93
|
||||
|
||||
Coming along nicely Matt!
__________________
[COLOR="Red"]I have the right foot of Subaru death![/COLOR] [SIGPIC][/SIGPIC] 365hp and 515nm New Beast to arrive April 2015 - 365hp, 450nm, 0-100 in 4.4sec. AMG Goodness! |
#94
|
||||
|
||||
Cant wait to see more pics Matt, coming along very quickly!
__________________
PerthWRX - Where gay singles meet! |
#95
|
||||
|
||||
good job matty
thanks fcuk those mudflaps have gone
__________________
I AM WE TODD DID... I AM SOFA KING WE TODD DID... |
#96
|
||||
|
||||
Quote:
__________________
MY93 Impreza GX 1.8L, 0hp, 0nm |
#97
|
||||
|
||||
all up how many hours spent workin on it now?
|
#99
|
||||
|
||||
Quote:
__________________
MY93 Impreza GX 1.8L, 0hp, 0nm |
#100
|
||||
|
||||
a few more =)
Stock WRX comes with a little press bent brace here, the NA models dont come with one.. problem Solution: Creative Werks fender braces from the US. Based on GD STI factory option but a shit load cheaper.. more on this later. Temp fitted at the moment, as they block access to the grommets. BP5 steering pump pipes don't match up with the GC8 quick rack. No probs, undo the one screw holding them together and they slot straight in BP5 motor on GC8 engine mounts in GC8 cross member, receiving a GC8 steering rack... and it all bolts up with minimal of fuss GC8 GX control arms for the time being, straight in GDA struts and GX hubs. The BP5 hubs weighed a decent amount more than the GX ones so they will do for the time being Which isn't a problem, cause the Legacy GT-B's stock brakes fit fine. Monster 330mm discs with hooge 2 pots. Eventually I'll replace with Brembo's and its just a matter of swapping the caliper One little doozy we ran into so far, the gear selector is a different length. BP5 on top, GC8 on bottom If anyones interested in the fender braces, they are nice solid product that ties the front clip of the car into the chassis and improves rigidity. The stock WRX/STI comes with a press bent steel sheet that you can literally bend by hand. They are a very popular mod in the US & Japan and quite a few companies make models. They cost me around $150 as I bought a couple and sold them on to friends, so if anyone is interested in a group buy (5+) PM me, as landed a single set in AU is $240 !
__________________
MY93 Impreza GX 1.8L, 0hp, 0nm |
Tags |
because racecar, project, retsej |
|
|
LinkBacks (?)
LinkBack to this Thread: http://www.perth-wrx.com/vb/general-subaru-discussion/9598-%5Bretsej%5D-project.html
|
||||
Posted By | For | Type | Date | |
1HZ Turbo thread - Page 9 | This thread | Refback | 13-08-2011 03:05 PM |