Links ECU - Page 11 - Perth-WRX.com

POLARBEAR666 · #**101** 20-04-2007, 07:29 PM

Is there much extra resolution in the new G3... from teh spec sheet it seems to say 11x16 which is what the normal links have.

If this is correct then its not an improvement in my opinion.

WRXTASY · #**102** 20-04-2007, 08:09 PM

I'm reading 440 fuel and ignition zones with 4d mapping.

Thats 20x22 with interpolation at a far higher processor speed than the old PossumLink V5 of 44s for the 01/02 WRX. The old board had 200 zones or 10x20 zones if you look at your manual.

Its got all the good stuff. Probably better than an Autronic now.

J

Hurtenstein · #**103** 20-04-2007, 08:13 PM

Big call... Let the slinging match begin..

POLARBEAR666 · #**104** 20-04-2007, 10:40 PM

What is 4D mapping is that just where the whole map is varied according to something else like coolant temp or something?

tuna · #**105** 21-04-2007, 03:32 AM

4d mapping allows an additional input to be used as a parameter on either fuel/ignition maps, usually you use throttle position as the 4th, as this allows you to setup wide open throttle vs cruise/mid throttle applications without having to use an over-all compensation map.

i would be supprised if link maintained 440 zones in 4D mapping for both tables, but then again- they have put a lot of work into this model from the last one!

POLARBEAR666 · #**106** 21-04-2007, 10:21 AM

If it did maintain all its zones in 4d mapping would it make a G3 LINK tuned car vs an old LINK car Chalk and cheese?

1C3 · #**107** 21-04-2007, 11:33 AM

i bought my link 2nd hand off here for $500. installed and tuned for $600 by RMS. it does the job.

tuna · #**108** 21-04-2007, 04:24 PM

Quote:

Originally Posted by POLARBEAR666

If it did maintain all its zones in 4d mapping would it make a G3 LINK tuned car vs an old LINK car Chalk and cheese?

got it in one!

11secWrx · #**109** 21-04-2007, 05:41 PM

My good old Link does the job 2.........................for now that is

POLARBEAR666 · #**110** 21-04-2007, 06:31 PM

HAHA it cracks me up that the second fastest rex in perth uses a LINK Electronic carby!

YAY. Certainly are reliable old things. No dead LINKS like autronics.

I might very well upgrade to G3 once Leigh has worked out all the goodies totally, eg flatshit cutout and launch control etc.