|
|
LinkBack | Thread Tools | Display Modes |
#12
|
||||
|
||||
Quote:
motec M800 plug and play.. The thing this ive had this setup up for 2yrs and since the build its started to happen..
__________________
I'm a jockey kunts... |
#13
|
|||
|
|||
Your pump controller still may not like the two pumps. I'd be looking at that if your relay is fine.
Secondary pumps should really be run off a separate fuse or relay, rather than the same one. |
#14
|
||||
|
||||
If it's an intermittent problem most likely culprit is usually an alarm system. Would get that checked out before tearing everything else apart.
|
#15
|
||||
|
||||
hmm i think ill wait for nick to have a look at it when it goes in for the tune..
__________________
I'm a jockey kunts... |
#16
|
||||
|
||||
Quote:
Jonno ive booked it in to subaru to get the re-wire done. so will see if that helps..
__________________
I'm a jockey kunts... |
#17
|
|||
|
|||
Personally i'd get this problem looked at ASAP
I'd imagine it could get abit dangerous losing all power ie: lights, power steering, brake booster? in the middle of traffic... could certainly cause an accident. Do you lose absolutely everything on the cut out ? |
#18
|
||||
|
||||
no just stalls still have all electrics working..
__________________
I'm a jockey kunts... |
#20
|
||||
|
||||
Tino, i just had to replace the Brandt module in the wifes bug, was doing a very similar thing to yours except it would restart straight away.
|
Tags |
cut, engine |
|
|