|
|
LinkBack | Thread Tools | Display Modes |
|
#1
|
||||
|
||||
Airbag possible fault question...
My friend sharee drives a MY10 wrx, she had an accident the other day and hit a car on a roundabout doing about 30kmph. She said she braked at about the same moment of impact, she also said that her car hit the other at 2 different angles as it had spun around on the wet road.
My question is how hard do you need to hit or how fast before the airbag goes off? She is very concernd maybe they were not functioning correctly?? Does anyone know or had experience with airbags?
__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR] |
#2
|
||||
|
||||
Airbag system has inertia sensors & a computer.
They will not deploy if basically the airbag will do more harm than the impact itself. P.s. if the airbags had deployed there's a good chance the car would have been written off as uneconomical to repair.
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#3
|
||||
|
||||
Yer i did say this to her, the cars pretty damaged, how much front end damage to write off a MY10? parts expensive?
__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR] |
#4
|
|||
|
|||
My 07 wrx got hit while I was stationary and the girl that hit me was doing 90kmph, all my airbags went off on the passengers side. That was a side impact to the b pillar on the passengers side.
__________________
MY11 STi R-Spec "ONALFOURS" |
#5
|
||||
|
||||
Fark 90kmph? thats a hell of an impact ur car must have been rooted?
__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR] |
#6
|
||||
|
||||
Wait for one of the panel beaters here to chime in, I'm not sure.
It's going to depend of if it needs a rad support or not.
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
#7
|
||||
|
||||
I think it will its lookin pretty messy in there bonet, rad, bumper, lights, wings etc.. where best place for her to send it?
__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR] |
#9
|
||||
|
||||
Was gonna say cool story bro-es but was being polite 90 is pretty fast.....
__________________
[COLOR="Blue"]If anyone needs T.I.G or M.I.G or small custom fabrication jobs done PM me.[/COLOR] |
#10
|
|||
|
|||
I was on the drivers side and I was badly injured... well bad whiplash and the seatbelt cut into my neck.
Zarb's panel shop in ossie park were awesome, it got towed there and they wrote it off immediately.
__________________
MY11 STi R-Spec "ONALFOURS" |
Tags |
airbag, fault, question |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Airbag fault after wheel install... do'h! | Patch | Cosmetic | 10 | 06-12-2010 01:10 AM |
RBT Officer asked a strange question?? | SPEC IV | Non-WRX Discussion | 22 | 06-05-2009 10:41 PM |
Airbag momo onto MY98 WRX | ninjawrx | Mechanicals | 2 | 23-08-2008 06:29 AM |
Clutch fitting question | gumby | Mechanicals | 5 | 29-01-2008 11:00 PM |
Upgraded TMIC and air splitter question | vivioman | Mechanicals | 14 | 08-12-2007 08:43 PM |