|
|
LinkBack | Thread Tools | Display Modes |
#1
|
||||
|
||||
Clunking noise on front passanger when accelerating
Hi guys!
Can somembody help me I have 97 gc8 and I recently stuffed up my centre diff on my gearbox. My brother and I just found a replacement second hand 4.44 gearbox for my ride.. Anyway while taking off the cv joints out we forgot it had pins to release For the gear box and we gave it a good tug for a while but didnt realise that we forgot to knock out the pins anyway we eventually got it out and replaced the gear box.. we took if for a test drive and on 3rd gear I took my foot of the gas an applyed the brakes and it made a thumping vibration at the front of the car so i completely stop the car to check it out for any damage to car not seeing anything wrong we drove it home and all the noise vibrations went away... The next day we took it for another test and now when I accelerate theres a clunk, clunk noise at the front passanger side for about 1second after take off...can any help me and tell whats wrong? Could it be because we tugged on the cvjoints when we replacing the gearbox? Theres no tear on the cv joints boots and visually I cant see the problem...please help me?
__________________
Mr gc8 |
#2
|
|||
|
|||
Make sure you put the CV's in the correct way, when lining up the holes for the pins they only fit in one way, sometimes you can knock the pin in without correct allignment but wont be easy to insert pins causing the CV to be incorrectly lined up.
If this is the case then you need to rotate the CV's 180 and insert the pins although am not sure if any damage has been caused fitting them incorrectly.
__________________
F1 Inspired |
#3
|
||||
|
||||
Is 4.44 the sti gearbox? What drivetrain do you have?
__________________
RB2666 |
#4
|
||||
|
||||
just checking but you changed the rear diff to suit yeah?
|
#5
|
||||
|
||||
Shit is loose, get it it on jack stands and tighten things up.
Or youve ruined the cv, pull it out, disassemble the inner cup and replace what is smashed.
__________________
Long live the WRC |
#6
|
||||
|
||||
Sounds like the CV.
Also check your springs, when the car is jacked up they can move around causing all sorts of problems. "done that"
__________________
1989 Legacy GT --> 2001 GD WRX --> 1999 GF8 WRX --> 2001 GD WRX |
#7
|
||||
|
||||
As above, have a look for something loose.
The next issue is you have a 97 WRX and have installed a 4.44 box. Did you change the rear diff to suit?
__________________
[COLOR="Gray"]550Nm off a 2L... Just wish it was in the dak dak...[/COLOR] |
#8
|
||||
|
||||
Well im the new owner and the guy that sold to me just said that it had 4.44 sti gear box dont know about the rear diff though,I spun the rear wheel and and both seems to spin in the same direction so it has LSD thats all I know,i think...
How do know if the rear diff 4.44 ratio with ripping it out? Ok thanks for the feed back guys Its a new day so im gonna get under my rex to check out all your tips......
__________________
Mr gc8 |
#9
|
||||
|
||||
I will check the cv, and the springs again...i just hope it isnt the gearbox
__________________
Mr gc8 |
#10
|
||||
|
||||
If you killed 1 centre diff I'd say your rear diff is the wrong ratio...
How did you kill the old centre diff out of interest?
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] |
Tags |
accelerating, clunking, front, noise, passanger |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
EOI.how much would u pay for a front lip | philta | General Subaru Discussion | 46 | 28-12-2006 04:33 PM |
Liberty Passanger Front CV/Driveshaft | teejay | Wanted | 0 | 10-12-2006 11:40 AM |
Clunking Noise | sikem rex | Mechanicals | 0 | 25-12-2005 12:35 PM |
Clunking from front | areS | Mechanicals | 4 | 31-10-2005 07:52 PM |
Strut Model Numbers | Intra | Mechanicals | 5 | 25-08-2005 06:23 AM |