|
|
LinkBack | Thread Tools | Display Modes |
#132
|
||||
|
||||
Thanks for all your advice guys. I'm going to stick with the mods I have for the moment as the bank account is very sad. Just took the car out for a 30min cruise to get a feel of what I'm up for. Turning the car on I get a shudder and then it seems to act normal. Car feels lumpy on the low revs but when warmed up it gets a little better. Response isn't to bad. Occasional back fire which is a little strange. On full boost the car seems great, lots of power (well for me anyway).
So far the problems I'm noticing are: - shudder on start/ cold take off - backfire - fuel seems to dissapear when not on boost I'm not complaining just sharing my thoughts on how i feel my car is driving at the moment. Would I take the mods i've done back? NO |
#133
|
||||
|
||||
Are they problems or just different than before. I suggest you always let the care warm up for a few minutes when doing a cold start. A bit of crack and pop on the over runs is normal but backfiring is a different story all together. Drive it for a few days and see how it responds to the mods and if there are still "issues" then take it back and discuss them with ASG.
__________________
Funny looking German Subaru |
#134
|
||||
|
||||
I havnt noticed those issues previous to the mods. Backfire isn't to bad I guess it's more of a pop as such haha. I'll drive it over the weekend and show you on Sunday then take it from there.
|
#135
|
||||
|
||||
just need more time on the tune grats on 260hp
__________________
Chinese Mexican [SIGPIC][/SIGPIC] |
#136
|
||||
|
||||
Quote:
|
#137
|
||||
|
||||
im getting a squeak noise when slowing down in 1st and 2nd gear. sounds like its coming from the front drivers side :S
|
#138
|
||||
|
||||
just use your breaks to slow down, solves the problem :P
|
#139
|
||||
|
||||
Quote:
Different wastegate actuator on the new turbo is 1 bar(stronger spring). Which means the boost controller is going to be set up completely differently than when it was running the TD04 with a 6-7psi spring. Weak spring = higher wastegate solenoid duty cycle to hold boost stronger spring = lower w/g solenoid duty to hold boost
__________________
[CENTER][SIGPIC][/SIGPIC][/CENTER] [CENTER][COLOR=#ff0000]Built Ej207: Semi-closed RA Cases - Wiseco Forgies - Manley rods - BC 272 cams - GDA Heads - billet f/whl - Vi-pec - WbO2 - 800cc Yellow tops - TD05-20G - 409Hp ath @ 1.75bar on E85[/COLOR][/CENTER] Last edited by Rossco; 14-10-2009 at 12:06 AM. |
#140
|
||||
|
||||
Checked for mice ?
|
Tags |
modadvice or help, time |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
It' my first time!! | slg | Introductions | 13 | 25-04-2008 09:49 PM |
Time to say hello! | holler | Introductions | 37 | 18-12-2007 10:16 PM |
hello - long time reader, first time poster :) | thebish | Introductions | 5 | 10-11-2005 04:02 PM |
R/C Time! | alcw | Non-WRX Discussion | 20 | 12-09-2005 10:21 PM |